| Search results - "rotary" |
Rotary stick disassembled20 viewsHere you can see a rotary joystick completely taken apart. You need a torx wrench. I bought a cheap one that had a few different sized bits in it. I don't recommend spending a lot since the number of times you will need a torx wrench is probably low.
|
|
Piano hinge23 viewsHere you can see the IPAC, the Druin rotary board, my torx wrench, and the piano hinge on the top of the panel. I highly recommend doing that. You can also see two holes in the back of the panel to run keyboard cables, etc.
|
|
Butchering a CD audio cable26 viewsI tried to use the end of a cd audio cable to provide a jumper for my Druin rotary interface, but it didn't work. At that point I went to Radio Shack.
|
|
Butt connectors28 viewsThis is the package of butt connectors that I purchased in order to get power to the rotary interface. We only ended up needing two of these I think. If you can avoid buying at Radio Shack, do it, since they are so over-priced.
|
|
Rigging power to the Druin board37 viewsGetting power to the rotary interface board was a pain. We ended up taking a butt joint from Radio Shack and connecting one end to the ground wire, and the other to the second power connection on the I-PAC. The first power didn't work.
|
|
Wiring the Druin rotary interface31 viewsHere you can see a close-up of the Druin board.
|
|
|
|
|
|
